diff --git a/config/examples/Creality/CR-10 V2/Configuration.h b/config/examples/Creality/CR-10 V2/Configuration.h
index b88a139995..bfe4cc11d4 100644
--- a/config/examples/Creality/CR-10 V2/Configuration.h	
+++ b/config/examples/Creality/CR-10 V2/Configuration.h	
@@ -658,10 +658,10 @@
 // Mechanical endstop with COM to ground and NC to Signal uses "false" here (most common setup).
 #define X_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
 #define Y_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
-#define Z_MIN_ENDSTOP_INVERTING ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the endstop.
+#define Z_MIN_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
 #define X_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
 #define Y_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
-#define Z_MAX_ENDSTOP_INVERTING ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the endstop.
+#define Z_MAX_ENDSTOP_INVERTING false // Set to true to invert the logic of the endstop.
 #define Z_MIN_PROBE_ENDSTOP_INVERTING ENABLED(CR10V2_BLTOUCH) // Set to true to invert the logic of the probe.
 
 /**
@@ -845,11 +845,13 @@
  * The probe replaces the Z-MIN endstop and is used for Z homing.
  * (Automatically enables USE_PROBE_FOR_Z_HOMING.)
  */
-#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
+//#define Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN
 
 // Force the use of the probe for Z-axis homing
 //#define USE_PROBE_FOR_Z_HOMING
-
+#if ENABLED(CR10V2_BLTOUCH)
+  #define USE_PROBE_FOR_Z_HOMING
+#endif
 /**
  * Z_MIN_PROBE_PIN
  *
@@ -868,7 +870,7 @@
 //#define Z_MIN_PROBE_PIN 32 // Pin 32 is the RAMPS default
 
 #if ENABLED(CR10V2_BLTOUCH)
-  #define Z_STOP_PIN 19 // Source DWIN2
+  #define Z_MIN_PROBE_PIN 19
 #endif
 
 /**