diff --git a/config/examples/Creality/Ender-5 Plus/Creality 4.2.2 GD32 (RELOADED UI)/Readme.md b/config/examples/Creality/Ender-5 Plus/Creality 4.2.2 GD32 (RELOADED UI)/Readme.md
new file mode 100644
index 0000000000..d7276c4d65
--- /dev/null
+++ b/config/examples/Creality/Ender-5 Plus/Creality 4.2.2 GD32 (RELOADED UI)/Readme.md	
@@ -0,0 +1,34 @@
+# Ender-5 Plus Configurations for Marlin Firmware
+
+> [!IMPORTANT]
+> The Ender-5 LCD stock firmware is only compatible with Creality firmware. The LCD standard UI will not function. This is expected. With the stock LCD firmware Marlin can only be controlled from a host over USB.
+
+## Marlin DGUS UI "Reloaded" Instructions
+
+The Ender-5 stock LCD can optionally use a customized Marlin DGUS interface. To use `DGUS_LCD_UI RELOADED` the stock LCD must be flashed with custom firmware.
+
+### Get the DWIN_SET
+
+- Download the `DWIN_SET` archive from https://github.com/MarlinFirmware/Configurations/raw/bugfix-2.1.x/config/examples/Creality/Ender-5%20Plus/DGUS-Reloaded/DWIN_SET.tar.gz
+- Extract the contents of the archive. You should now have a folder called `DWIN_SET`.
+
+### Prepare the SD Card
+
+- Format a Micro-SD card, selecting FAT32 for the file system and 4096 bytes sector size. These parameters are required for the procedure to work.
+- Copy the `DWIN_SET` folder to the root of the Micro-SD card.
+- Unmount and unplug your Micro-SD card.
+
+### Flash the touchscreen
+
+- Turn off and unplug your printer (both power and USB).
+- You will need to access the Micro-SD slot on the back of the touchscreen (not the one that may be on your mainboard). If necessary, open the printer to access this slot.
+- Insert the Micro-SD card into the screen SD slot.
+- Plug the printer's power cable back in (but not the USB cable) and turn on the printer.
+- After a few seconds the screen background will turn blue and the firmware flash will begin. _Do not cut power to the printer while the procedure is running!_
+- When the procedure ends the screen will display a blue background with an END message on the first line and a summary.
+- Turn off the printer. Remove the Micro-SD card from the touchscreen. Reassemble the printer if needed.
+- The touch-screen firmware is now up-to-date.
+
+## Restoring Factory Firmware
+
+The original firmware can be restored by downloading the [Ender-5 Plus firmware](//www.creality.com/download) from Creality. You can follow the same LCD flashing procedure using the Creality-provided `DWIN_SET` folder.