diff --git a/config/examples/AnyCubic/Chiron/Configuration_adv.h b/config/examples/AnyCubic/Chiron/Configuration_adv.h
index b2642511b8..32034629a3 100644
--- a/config/examples/AnyCubic/Chiron/Configuration_adv.h
+++ b/config/examples/AnyCubic/Chiron/Configuration_adv.h
@@ -508,7 +508,7 @@
  */
 #define USE_CONTROLLER_FAN
 #if ENABLED(USE_CONTROLLER_FAN)
-  #define CONTROLLER_FAN_PIN TG_FAN1_PIN    // Set a custom pin for the controller fan
+  #define CONTROLLER_FAN_PIN FAN1_PIN       // Set a custom pin for the controller fan
   //#define CONTROLLER_FAN_USE_Z_ONLY       // With this option only the Z axis is considered
   //#define CONTROLLER_FAN_IGNORE_Z         // Ignore Z stepper. Useful when stepper timeout is disabled.
   #define CONTROLLERFAN_SPEED_MIN         0 // (0-255) Minimum speed. (If set below this value the fan is turned off.)